Introduction of gap filler

1. The crevices should be clean and free of debris and water. For tiles with high water absorption, the crevices can be moistened in advance.
2. Clean the gaps that need to be filled so that they are free of dust, debris and water.
3. The depth of the gap should not be less than 0.6cm or brick height.
4. For ceramic tiles with too large pores, they should be facing protection before caulking, so as not to affect or contaminate the brick surface, or use a special jointing knife for caulking.
5. Stir the color waterproof and mildew-proof grout at the ratio of 3.3～3.5:1 (powder: water) into a paste-free paste, let it stand for 3～5 minutes and then stir for 1～2 minutes before use .
6. Using a rubber caulking knife or a soft scraper, press the mixed color waterproof and mildew-proof caulking agent into the gap along the diagonal of the brick to fill the gap and scrape away the excess. The construction time is 1 to 2 hours.
7. After the caulk is completely cured in 24 hours, remove the remaining stains with water or a special cleaning agent.

1. Jinshi caulking agent can be applied seven days after cement paving (applicable after two days for tile adhesive paving), the construction temperature should not be lower than 0 degrees.
2. First, the surface of the mosaic or stone and the joints must be cleaned up. It is easy to wet the surface with a damp cloth, but do not leave water, so as to reduce the small holes on the mosaic from inhaling paint and cement, and ensure its coloring and finality. Degree of condensation.
3. To help control the color and reduce chalking, wipe the surface with a cotton cloth or a clean dry towel within 1-2 hours.
4. In the first 72 hours, care must be taken to prevent the sealant from drying (especially the construction surface exposed to the sun). At this time, natural kraft paper can be used to cover the construction surface (it is better not to replace it with plastic cloth or newspaper) to prevent Other construction work soiled the newly completed joints. It can be moisturized by spraying water 2-3 times in the outdoor caulking.

1. The powder and water ratio of the grout is slightly different depending on the width of the brick gap and the dryness of the environment. The narrow gap can be relatively thinner. The width of the brick gap should be 1.5～5mm (when using coarse sand grout, The width of the brick gap is 2～13mm).
2. Do not use acidic cleaners to clean the caulked tiles.
3. It cannot be constructed outside of 5-40℃ and under rainy conditions.
4. Special joint sealants such as neutral glue should be used at the expansion joints.
5. During the construction, try not to have too thick joint filler remaining on the brick surface, so as not to be difficult to clean after bonding.
6. Avoid pressing, scratching and raining on the jointed tiles and jointing agent within 24 hours.
7. After the construction of the black caulking agent, clean the base surface with a dry cloth as soon as possible (within 10 minutes). Wait for 24 hours to dry, then clean the remaining stains with water to avoid whitening of the caulk.
8. Expansion joints should be left during large-area construction. 5-6 hours after construction, it needs to be cured once, and after 24 hours, it needs to be cured for the second time.
9. The product is corrosive and should avoid contact with eyes. If it accidentally gets into it, rinse it with plenty of water immediately. In severe cases, it should be sent to the hospital immediately.